USE COUPON CODE...USREEL...FOR 12% OFF ALL FISHING REELS

Like the company's spinning reels the new SC1000 baitcaster(SuperCaster) was designed to address a problem with existing reel design, and in this case that is the traditional levelwind guide design which becomes an obstacle to the cast by adding friction from the sides of the eyelet. In addition traditional eyelets are the cause of many backlashes when the line to the eyelet is at a sharp angle. This angle causes the spool to pause as the line catches on other line and then has to accelerate to catch up. This acceleration can start a backlash if the angler is not aggressively thumbing the spool. So what has US Reel done to address the issue? They have created a reel that has no eyelet at all, allowing the line to leave the reel straight and virtually friction free regardless of line position. So how does a baitcaster with no eyelet lay down line evenly on the spool? US Reel has created the "Angled Bar Levelwind" which is a rotating angled bar that creates a see-saw effect to guide the line side to side instead of an eyelet. While the rolling motion of the bar levels the line it does not restrict the line like a traditional eyelet during casting. After testing the concept US Reel discovered that by adjusting the levelwind height the bar was also regulating cast control. This adjustable bar allows for maximum casting distance when the bar is adjusted at the lowest setting, but anglers will have to thumb the spool more aggressively than when the bar is set higher. Another interesting aspect of the SC1000's design is that the reel features a "reverse rotation" spool and the line comes out from under the spool and up to the bar. This design creates an angle which makes the adjustable levelwind function, and also reduces backlashes.

ABLe “see-saw” levelwind

Straight line casting for maximum distance

Reverse rotation spool

Adjustable levelwind height for maximum control

Anodized aircraft aluminum internal main gear

Aluminum body and sidecovers with 6-layer SUPERCOAT6™ process 3 Stainless Steel Ball Bearings

Highest-quality INA infinite anti-reverse bearing

Forged, 2-tone anodized Spool

Super-hard titanium nitride (TIN) coated levelwind

Thumbar spool release

Stainless steel spool shaft

Dual drag disk system

Fast 6.6 to 1 gear ratio

28” per turn retrieve rate

Weighs 8.2 ounces

Mono capacities (lb/yd) 10/144, 12/131, 14/106, 20/74

Braid capacities (lb/yd) 10/221, 20/148